Reverting To The Factory Default Settings - Sony STR-DN1060 Parts And Controls

[218] Adjusting Settings

Reverting to the factory default settings

You can clear all memorized settings and restore the receiver to the factory default settings
by the following procedure. This procedure can also be used to initialize the receiver before
you use it for the first time.
Be sure to use the buttons on the receiver to perform this operation.
1. Turn off the receiver.
2. Hold down
[CLEARING] flashes on the display panel for a while, then changes to [CLEARED !].
Note
It takes a few minutes for the memory to be cleared completely. Do not turn the receiver
off until [CLEARED !] appears on the display panel.
[219] Troubleshooting
PROTECTOR
The receiver will automatically turn off after a few seconds. Check the followings:
There may be an electrical surge or power failure. Unplug the AC power cord (mains
lead) and then plug in the cord again after 30 minutes.
The receiver is covered and the ventilation holes are blocked. Remove the object
covering the ventilation holes of the receiver.
The impedance of the connected speakers is below the rated impedance range indicated
on the back panel of the receiver. Reduce the volume level.
Unplug the AC power cord (mains lead) and let the receiver cool down for 30 minutes
while performing the following troubleshooting:
Disconnect all of the speakers and subwoofer.
Check that the speaker wires are tightly twisted on both ends.
Connect the front speaker first, increase the volume level and operate the receiver for at least 30
minutes until it completely warms up. Then, connect each additional speaker one by one and test
each additional speaker until you detect which speaker is causing the protection error.
After checking the above items and fixing any problems, plug in the AC power cord
(mains lead) and turn on the receiver. If the problem persists, consult your nearest Sony
dealer.
Reverting to the factory default settings
(on/standby) on the receiver for 5 seconds.
Error messages