Sony STR-DN1060 Parts And Controls page 139

1. Select the input for which you want to check information.
2. Press DISPLAY MODE on the receiver repeatedly.
Each time you press DISPLAY MODE, the display will change cyclically as follows:
Index name of the input (*1) - Input you selected - Sound field currently applied (*2) -
Volume level - Stream information (*3)
When listening to FM radio
Preset station name (*1) - Frequency - Sound field currently applied (*2) - Volume level
When receiving RDS broadcasts (for European and Asia-Pacific
models only)
Program service name or preset station name (*1) - Frequency, band and preset
number - Sound field currently applied (*2) - Volume level
*1
Index name appears only when you have assigned one to the input or preset station. Index name
does not appear if only blank spaces have been entered or it is same as the input name.
*2
[PURE.DIRECT] appears on the display panel when the Pure Direct function is activated.
*3
Stream information may not be displayed.
Note
Characters or marks in some languages may not be displayed.
[134] Adjusting Settings
Setting up the receiver using Easy Setup
When you turn on the receiver for the first time or after the receiver is initialized, the Easy
Setup screen appears on the TV screen. You can set up the following settings for the
receiver by following the instructions on the Easy Setup screen.
Speaker Settings
Check your speaker system and perform automatic calibration according to the
configuration and arrangement of your speaker system.
Internet Settings
Configure settings to connect the receiver to the network.
Note
Switch the input of the TV to the input to which the receiver is connected to use this
function.
Auto Calibration is not available when [Bluetooth Mode] is set to [Transmitter].
Easy Setup