Before You Perform Auto - Sony STR-DN1060 Parts And Controls

**
The measurement result may be not utilized, depending on the audio formats.
Note
The D.C.A.C. is designed to achieve proper sound balance for your room. However, you
can adjust the speaker levels manually according to your preference using [Test Tone].
[44] Preparation
2. Before you perform Auto Calibration
Before you perform Auto Calibration, check the following items:
Set up and connect the speakers.
Do not connect any microphones other than the supplied optimizer microphone to the
AUTO CAL MIC jack.
If using a bi-amplifier connection or speakers with a front B connection, set the
assignment for the SPEAKERS SURROUND BACK/BI-AMP/FRONT HIGH/FRONT B
terminals properly.
Set the speaker output to a setting other than [SPK OFF].
Disconnect the headphones.
Remove any obstructions between the optimizer microphone and the speakers.
For accurate measurement, make sure the environment is quiet and free from noise.
Note
Auto Calibration is not available when [Bluetooth Mode] is set to [Transmitter].
The speakers emit very loud sound during the calibration and the volume cannot be
adjusted. Be considerate of your neighbors and any children who are present.
If the muting function has been activated before you perform Auto Calibration, the muting
function will shut off automatically.
It may not be possible to take the correct measurements or to perform Auto Calibration at
all if special speakers such as dipole speakers are used.
[45] Preparation
3. Connecting the optimizer microphone
Tips for automatic calibration (Auto Calibration)
Tips for automatic calibration (Auto Calibration)