Selecting The Auto Calibration Type (Calibration Type) - Sony STR-DN1060 Parts And Controls

This function does not work in the following cases:
[Analog Direct] is being used.
Headphones are connected.
[Auto Calibration] has not been performed.
[Bluetooth Mode] is set to [Transmitter]
The receiver may play signals at a lower sampling frequency than the actual sampling
frequency of the input signals, depending on the audio format.
[142] Adjusting Settings

Selecting the Auto Calibration type (Calibration Type)

You can select a calibration type after you have performed the Auto Calibration and saved
the settings.
1. Select [Setup] - [Speaker Settings] from the home menu.
2. Select [Calibration Type].
3. Select the setting you want.
Full Flat: Makes the measurement of frequency from each speaker flat.
Engineer: Sets to "the Sony listening room standard" frequency characteristics.
Front Reference: Adjusts the characteristics of all of the speakers to match the
characteristics of the front speaker.
Off
Note
This function does not work in the following cases:
[Analog Direct] is being used.
Headphones are connected.
[Bluetooth Mode] is set to [Transmitter]
The receiver may play signals at a lower sampling frequency than the actual sampling
frequency of the input signals, depending on the audio format.
[143] Adjusting Settings
Setting how to assign the surround speaker terminals
(Speaker Pattern/Surround SP Assign) (for STR-DN1060
Speaker Settings
Speaker Settings