Lan Connection; Cannot Connect To The Network - Sony STR-DN1060 Parts And Controls

If you use a partitioned USB device, only audio files on the first partition can be played.
Playback is possible up to nine levels (including the [ROOT] folder).
There are more than 500 folders (including the [ROOT] folder).
There are more than 500 files.
Files that are encrypted, protected by passwords, etc. cannot be played.
[258] Troubleshooting
Cannot connect to the network using WPS via a wireless

LAN connection.

You cannot connect to a network using WPS if your access point is set to WEP. Set up
your network after searching the access point using the access point scan.
[259] Troubleshooting

Cannot connect to the network.

Check that the LAN cable is connected to the receiver when you want to connect the
receiver to the network via a wired LAN connection.
Check the network information. If the connection failed, set up the network connection
again.
If the receiver is connected through a wireless network, move the receiver and the
wireless LAN router/access point closer to each other and perform the setup again.
Make sure that you use a wireless LAN router/access point.
Make sure that the wireless LAN router/access point is turned on.
Check the settings of the wireless LAN router/access point and perform the setup again. For
details on the settings of devices, refer to the operating instructions of the devices.
Wireless networks are influenced by electromagnetic radiation emitted by microwave ovens and
other devices. Move the receiver away from these devices.
[260] Troubleshooting
Cannot control the receiver using a "SongPal" device.
Network connection
Network connection
Network connection