The Fm Stereo Reception Is Poor; You Cannot Tune To Radio Stations; An Error Message Appears; Cannot Connect To The Network - Sony STR-ZA5000ES User Manual
Multi channel av receiver
Hide thumbs
Also See for STR-ZA5000ES:
- Operating instructions manual (57 pages) ,
- Startup manual (2 pages) ,
- Service manual (102 pages)
Table of Contents
Advertisement
[198] Troubleshooting
Tuner
The FM stereo reception is poor.
Set the FM station receiving mode to the monaural mode.
[199] Troubleshooting
Tuner
You cannot tune to radio stations.
Check that the antennas (aerials) are connected securely. Adjust the antennas (aerials) and
connect an external antenna (aerial) if necessary.
The signal of the stations is too weak with automatic tuning. Use direct tuning.
Make sure you set the tuning scale correctly (when tuning to AM stations with direct tuning).
No stations have been preset or the preset stations have been cleared (when tuning by
scanning preset stations is used). Preset the stations.
Press DISPLAY repeatedly on the receiver so that the frequency appears on the display
panel.
[200] Troubleshooting
USB devices
A USB device is not recognized.
Turn off the receiver, then disconnect the USB device. Turn on the receiver again and
reconnect the USB device.
Connect a compatible USB device. USB devices are only supported when formatted with
the FAT16 or FAT32 file systems.
The USB device does not work properly. Refer to the section on how to deal with this
problem in the operating instructions of the USB device.
[201] Troubleshooting
USB devices
A USB device cannot be connected to the USB port.
The USB plug is being inserted upside down. Connect the plug in the correct orientation.
[202] Troubleshooting
Network connection
An error message appears.
Check the nature of the error. See “Network features message list.”
[203] Troubleshooting
Network connection
Cannot connect to the network.
Check that the LAN cable is connected to the receiver when you want to connect the
receiver to the network via a wired LAN connection.
Check the network information. If [Not Connected] appears, set up the network connection
again.
[204] Troubleshooting
“BRAVIA” Sync (Control for HDMI)
The Control for HDMI function does not work.
Check the HDMI connection with the receiver (refer to the supplied Startup Guide).
Enable the Control for HDMI function on the TV. For details, refer to the operating
instructions of the TV.
Wait for a while, and then try again. If you unplug the receiver, it will take a while before the
operation is completed. Wait for 15 seconds or longer, and then try again.
Check the Control for HDMI settings on the connected device. Refer to the operating
instructions of the connected device.
If you unplug the HDMI cable or change the connection, repeat the procedures of “Preparing
for “BRAVIA” Sync.”
Make sure your TV is connected to the HDMI OUT A jack of the receiver.
Make sure the HDMI OUTPUT setting is set to [HDMI A] or [HDMI A+B].
When [Control for HDMI] is set to [Off], “BRAVIA” Sync does not work properly, even if the
device is connected to the HDMI IN jack.
Make sure the connected device supports the Control for HDMI function.
Enable the Control for HDMI function on the connected device. For details, refer to the
- Quick Links:
- Enjoying Video and Sound
- Adjusting Settings
Hide quick links:
Advertisement
Table of Contents
