Symbol PDT 1100 Product Reference Manual page 64

PDT 1100 Terminal Product Reference Guide
• Select the 3:LINKUP TIME to select the timeout length (in seconds) to be
applied when a link is to be established. Select 1:ON or 2: OFF, then press ENT.
To return to the SET PROTOCOL menu, press the C key.
• Select the 4:FIELD SPACE to select whether space codes in the tail of a data
field should be ignored or handled as data. Select 1:Ignore or 2: Data, then
press ENT. To return to the SET PROTOCOL menu, press the C key.
Com Port Parameters
To set the interface port:
1. Select 3:COM PORT on the SET COM menu. The following screen displays.
2. Select one of the following:
• Press 1 to select the optical or direct-connect interface port used for user
programs written in BASIC 3.0 Interpreter (OPEN "COM:" or XFILE statement).
• Press 2 to select the optical or direct-connect interface port used for
downloading or uploading files in System Mode.
3. Press ENT, or C to return to the Set Connector screen.
Protocol Type Setting
To set the communications protocol type:
1. Select the 4:PROTOCOL TYPE on the SET COM menu. The following screen
displays:
4-20
SET COM PORT
1: BASIC
OPT IFC
2: SYSTEM
OPT IFC
PROTOCOL TYPE
1: PROTOCOL
2: IRPROTOCOL