Symbol PDT 1100 Product Reference Manual page 60

PDT 1100 Terminal Product Reference Guide
Table 4-4. Comm. Parameter Default for Direct-Connect Interface (Continued)
Communications Parameters
PROTOCOL (Protocol options)
To change communication environments:
1. Select the 6: COM on the Set System menu. The following screen displays:
2. Select one of the following:
• Press 1 to select the communications parameters setting screen for the optical
interface.
• Press 2 to select the communications parameters setting screen for the direct-
connect interface.
• Press 3 to select the interface port setting screen.
• Press 4 to select the communications protocol type setting screen.
3. Press ENT to enter your selection, or C to return to the Set System menu.
The following sections provide instructions for setting each of these options.
4-16
Adds serial numbers to data blocks.
H. PARITY ON: Adds a horizontal parity.
LINKUP TIME: 30 seconds
FIELD SPACE: Ignore
SET COM
1:OPTICAL
2:CONNECTOR
3:COM PORT
4:PROTOCOL TYPE
Defaults