Table of Contents
Advertisement
Connector Parameters
To set the communications parameters for the direct-connect interface:
1. Select 2:CONNECTOR on the SET COM menu. The following screen displays:
2. Select one of the following options using the numeric keys or F5 and F6 keys.
Note: If the IR protocol is selected, the parity bit, character length, and stop
bit length settings are ignored.
a. Select 1:TRANSMIT SPEED to display the transmission speed screen. Select
the transmission speed using the numeric keys or F5 and F6 keys.
b. Select 2:PARITY BIT for the parity screen. Select the parity (none, odd or even)
using the numeric keys or F5 and F6 keys.
c. Select 3:DATA BIT to display the character length screen. Select the character
length using the numeric keys or F5 and F6 keys.
d. Select 4:STOP BIT to set stop bits. Select the stop bit length using the numeric
keys or F5 and F6 keys.
e. Select 5:PROTOCOL to set communications protocol. Select a screen using
the numeric keys or F5 and F6 keys, then press ENT.
Note: If the IR protocol is selected, the serial number and horizontal parity
settings are ignored.
•
Select 1:SERIAL NO. on the SET PROTOCOL menu to determine whether the
system should add serial numbers to data blocks. Use the numeric keys or F5
and F6 keys to select 1:ON or 2:OFF, then press the ENT key. To return to the
Set Protocol menu, press the C key.
•
Select 2:H.PARITY to select whether the system should add a horizontal parity.
Select 1:ON or 2: OFF, then press ENT. To return to the Set Protocol menu,
press the C key.
SET CONNECTOR
1:TRANSMIT SPEED
2:PARITY BIT
3:DATA BIT
4:STOP BIT
5:PROTOCOL
System Mode
4-19
- Quick Links:
- Initializing the Pdt 1100
Hide quick links:
Advertisement
Table of Contents
