Initial Mode - Picotest M3500A User Manual

Press CONFIG + SHIFT + FILTER for scanning configuration. Use
buttons to scroll through submenus. Press ENTER to select
▷
"OPERATION" submenu. Use
(COUNT), scan interval (TIMER) and store (STORE) options. Then press
ENTER on your selection. Use
a nd to increase or decrease the numbers to a desired value. For
△ ▽
STORE option, you can select ON to instruct the meter to store the
measurement results for later retrieving or select OFF. Press ENTER to
set the value.
How to open and close the channels
Press CONFIG + SHIFT + FILTER for scanning configuration. Use
buttons to scroll through submenus. Press ENTER on "----" when you
▷
need to close a specific channel. Press ENTER again on "CHANNEL". Use
and to move through the digits and
◁ ▷
decrease the numbers to the desired channel number. Press ENTER to
close the channel. To open all channels, simply press ENTER on "OPEN
ALL" option. Press SHIFT + FILTER to scan as shown as Figure 4-32.

4.4.7 Initial Mode

The section contains two selections: "DEFAULT" and "SAVE DATA". You
and
◁
and
◁
Figure 4-32
105 105
105 105
to switch among scan count
▷
to move through the digits and
▷
a nd
△ ▽
and
◁
and
◁
to increase or