Picotest M3500A User Manual page 81

The specified target value is store in a volatile memory and will be
cleared after the meter has been turned off or a remote interface reset.
How to use % (Percent) function
There are two ways to make a percent measurement: Through the front
panel operation or through the remote interface operation.
Front Panel Operation
To specify a target value, you need to configure Percent function by
pressing CONFIG + %, then use and to move through the digits
◁ ▷
and and buttons to increase or decrease the numbers to a desired
△ ▽
target value. Press ENTER to set the value. Press % to activate this
function. And then observe the calculated percent value on the display as
shown as Figure 4-15.
Note: Press % again to disable this function. The "MATH" annunciator
※
on the display indicates the state of a mathematical feature.
Figure 4-15
Remote Interface Operation
Use the following commands to enable and configure Percent function:
CALCulate:FUNCtion PERCent
81 81 81 81