Picotest M3500A User Manual page 103

AutoZero OFF,AutoGain OFF,AutoRange OFF, Scan Timer=0,60Hz
single
(Slow 4.5 & Fast 5.5) 0.1
function(VDC)
(Slow 5.5 & Fast 6.5) 1
AutoZero OFF,AutoGain OFF,AutoRange OFF, Scan Timer=0,60Hz
Mix function
(Slow 4.5 & Fast 5.5) 0.1
(VDC+2WRES)
(Slow 5.5 & Fast 6.5) 1
How to program each channel with measurement function
Press CONFIG + SHIFT + DIGITS for scanning configuration. Use
to scroll through submenus. Press ENTER on "SET SCAN CHA"
▷
submenu. Use
◁
use a nd to switch among the measurement functions. Leave an
△ ▽
unused channel with a blank space (----). Press ENTER when ten
channels are all defined.
How to configure scan count, scan interval and store
measurement readings
Press CONFIG + SHIFT + DIGITS for scanning configuration. Use
buttons to scroll through submenus. Press ENTER to select
▷
"OPERATION" submenu. Use
(COUNT), scan interval (TIMER) and store (STORE) options. Then press
ENTER on your selection. Use
a nd to increase or decrease the numbers to a desired value. For
△ ▽
STORE option, you can select ON to instruct the meter to store the
measurement results for later retrieving or select OFF .Press ENTER to
set the value.
How to open and close the channels
Press CONFIG + SHIFT + DIGITS for scanning configuration. Use
buttons to scroll through submenus. Press ENTER on "----" when you
▷
need to close a specific channel. Press ENTER again on "CHANNEL". Use
NPLC
(Fast 4.5) 0.02
(Slow 6.5) 10
NPLC
(Fast 4.5) 0.02
(Slow 6.5) 10
and to switch from channel 1 to channel 10, and
▷
and
◁
and
◁
103 103
103 103
Take Time with 2000 Readings(sec)
68
74
105
408
Take Time with 2000 Readings(sec)
306
318
442
1710
to switch among scan count
▷
to move through the digits and
▷
rate(ch/s)
29.4
27.0
19.0
4.9
rate(ch/s)
6.5
6.3
4.5
1.2
and
◁
and
◁
and
◁