Picotest M3500A User Manual page 37

Select the auto-range function by pressing AUTO button on the front
⑤ ⑤ ⑤ ⑤
panel or use
△
Connect test leads to your source signal and observe the reading
⑥ ⑥ ⑥ ⑥
shown on the display. If the input signal is greater than the allowed
range, an overflow message "OVLD" will be displayed.
6
4
Note: The rear terminal panel also can be used via the same
※
procedures as the front panel. (See Figure 3-5)
and buttons to select desired range.
▽
1
5
4 3
Figure 3-4
Figure 3-5
37 37 37 37
2