Calibration Information - Picotest M3500A User Manual

for each microprocessor.
How to check the firmware revision
Press MENU and then use
ENTER to select it. Again use
Press ENTER to select it. The multimeter gives three numbers in
xx-xx-xx format on the display. The first number is the firmware revision
number for the measurement microprocessor; the second number is for
I/O processor and the third number is for the front-panel processor. The
locations of the buttons are shown with red rectangle frames in Figure
4-36.

4.4.11 Calibration Information

M3500A will show the latest calibrated date and the next calibration date
on the display after following the operation below. The location of the
buttons is shown with red rectangle frames in Figure 4-37.
How to see the calibration information
Press MENU then locate "CALIBRATE" option using
ENTER to select it. Use
and the next calibration date.
and to locate "SYSTEM" submenu. Press
◁ ▷
and
◁
Figure 4-36
and to switch from the last calibrated date
◁ ▷
109 109
109 109
to locate "REVISION
▷
◁
option.
"
and . Press
▷