Stepping (Step) - Picotest M3500A User Manual

and to move through the digits and
◁ ▷
decrease the numbers to the desired channel number. Press ENTER to
close the channel. To open all channels, simply press ENTER on "OPEN
ALL" option. Press SHIFT + DIGITS to scan.
The locations of the buttons are shown with red rectangle frames in
Figure 4-31.

4.4.6 Stepping (Step)

Stepping is scanning with a specified time delay between taking input
signal through the defined channels.
Note: Setting range of scanner card is only limited on DCV, DCI, ACV,
※
ACI, Frequency, Period and Resistance functions.
How to program each channel with measurement function
Press CONFIG + SHIFT + FILTER for scanning configuration. Use
to scroll through submenus. Press ENTER on "SET SCAN CHA"
▷
submenu. Use
◁
use a nd to switch among the measurement functions. Leave an
△ ▽
unused channel with a blank space (----). Press ENTER when ten
channels are all defined.
How to configure scan count, scan interval and store
measurement readings
Figure 4-31
and to switch from channel 1 to channel 10, and
▷
104 104
104 104
a nd to increase or
△ ▽
and
◁