Min/Max - Picotest M3500A User Manual

CALCulate:STATe {OFF|ON}
CALCulate:STATe?
CALCulate:PERCent:TARGet {<value>|MINimum|MAXimum}
CALCulate:PERCent:TARGet? [MINimum|MAXimum]

4.3.3 Min/Max

Definition
When the Min/Max function is enabled, the multimeter takes in a series
of readings from the measurements, stores the minimum and maximum
readings in the memory, and then calculates the average value of all
readings. The number of readings taken since Min/Max operation is
enabled is recorded as well. These data are stored in a volatile memory
and will be cleared when the meter is turned off, or when the MIN/MAX is
turned on, or after a remote interface reset. The meter beeps every time
when it captures a new minimum or maximum.
How to use Min/Max
You can use the Min/Max feature either through the front panel operation
or the remote interface operation.
Front Panel Operation
First of all, you select the measurement function you wish to use, and
then press MIN/MAX button to enable the Min/Max function. To read the
min/max value, the average value or the readings count, you can press
CONFIG button and then MIN/MAX button. Use and buttons to
◁ ▷
switch between those values. The locations of the buttons are shown
with red rectangle frames in Figure 4-16.
Note: Press MIN/MAX again to disable this feature. The "MATH"
※
anunnciator on the display indicates the state of a mathematical feature.
82 82 82 82