Remote Interface Selection; Input Terminal Switch - Picotest M3500A User Manual

:UNIT?
SENSe
TCOuple:TYPE {E|J|K|N|R|S|T}
SENSe:
TCOuple:SIMulated {<value>|MINimum|MAXimum}
SENSe:

4.1.9 Remote Interface Selection

The multimeter supports both GPIB/RS-232 and USB interfaces, but only
one interface can be activated at a time. If you are using GPIB, you must
set the address for the multimeter. You can set the address to any value
from 0 and 31. The address is set to "22" when the multimeter is shipped
from the factory.
Note: The remote interface can be set through the front panel
※
operations only.
How to select a remote interface
Press MENU and then use
ENTER on your choice of USB or GPIB interface.
How to set address when using GPIB
Press MENU and then use
to set address. Use
desired address. Press ENTER to set it.

4.1.10 Input Terminal Switch

Definition
You can select either the front input terminals or the rear input terminals
for your measurements. There are 5 input terminals in the front panel as
well as the rear panel. If the rear terminal is enabled the REAR
annunciator at the upper side will be shown.
Default
The default situation is the front terminals.
and to select INTERFACE. Then Press
◁ ▷
and to access INTERFACE. Select GPIB
◁ ▷
a nd
◁ , ▷ , △ ▽
69 69 69 69
to adjust the numbers to the