Picotest M3500A User Manual page 95

because there is no I/O delay. But turning off the display will not affect
the messages displayed from the RECALL, MENU and CONFIG
operations.
You can send a message through the remote interface from your PC
terminal to the lower row display and will substitute the original display.
Default
The display default is "ON". The "On/Off" selected by you is stored in a
volatile memory and the default "ON" will be restored when the meter is
power-off.
How to control the display
You can control the display through the front panel operation or through
the remote interface operation. The remote interface operation has
higher priority over the front panel operation.
Front Panel Operation
Use the following steps to control the display: Press MENU button then
use and buttons to locate "SYSTEM" submenu. Press ENTER to
◁ ▷
select it, and then again use and buttons to locate "DISPLAY"
◁ ▷
submenu. Press ENTER to select it, and then find ON or OFF by using
◁
and buttons. Press ENTER on your selection. The locations of the
▷
buttons are shown with red rectangle frames in Figure 4-26.
Procedures: MENU → → → → SYSTEM → → → → DISPLAY → → → → {ON|OFF}
Figure 4-26
Remote Interface Operation
95 95 95 95