Table of Contents
Advertisement
Transport cable removal
Remove the LVPS. See
1.
2.
Remove the transport belt assembly. Leave the photoconductor units in place. See
removal" on page
Disconnect the transport cable from the system board at JTPS1 connector (A).
3.
Note: The cable connector on the system board end of the cable is smaller than the connector on the front
access door, and it may be easier to get that end through the openings.
"Low-voltage power supply (LVPS) removal" on page
4-179.
5026
4-127.
"Transfer module
Repair information
4-181
Previous
Next
Go Back
Advertisement
Table of Contents
