Adf Transport Drive Motor Bracket Assembly With Cable Removal - Lexmark X792 7562-4xx Service Manualv

7562

ADF transport drive motor bracket assembly with cable removal

See "ADF feed and drive" on page 7-25
1.
Remove the ADF rear cover. See
2.
Remove the ADF transport drive motor bracket tension spring (A).
3.
Bend up the cable clip (B) on top of the bracket, and remove the cables from the clip.
4.
Disconnect the cable from the ADF controller card, and remove the cable from the cable clips.
Note: Note the cable routing for reinstallation.
5.
Remove the two screws (C).
6.
Slide the ADF transport drive motor bracket to the left to loosen the transport belt.
7.
Remove the bracket and cable.
4-200
Service Manual
for the part number.
"ADF rear cover removal" on page
C B
4-171.
A
Previous
Next
Go Back