Table of Contents
Advertisement
5026
Error code
57 Configuration
Change
Held Jobs May Not
Be Restored
58 Too Many Flash
Options
58 Too Many Trays
Attached
59 Incompatible Tray
<x>
61 Defective Disk
62 Disk full
63 Unformatted disk
64 Unsupported disk
format
80 Fuser Near Life
Warning
Service Manual
2-16
Action
Configuration changes may be:
• Code version changes
• Paper handling options removed
• The disk was installed from a different model or speed of printer.
Too many flash options are installed. To continue:
1. Turn off and unplug the printer.
2. Remove the excess flash memory.
3. Plug in the printer, and turn it on.
If this does not fix the problem, replace the system board. See
page
4-163.
1. Turn off and unplug the printer.
2. Remove options until the supported number of options for that model.
3. Plug in the printer, and turn it on.
If this does not fix the problem, replace the system board. See
page
4-163.
There is an incompatible tray. To remove the option:
1. Turn off and unplug the printer.
2. Remove all option trays.
3. Install one option, plug in the printer and turn it on.
4. Continue adding one option at a time and checking whether the error occurs.
5. Install all options except the one identified as a problem.
- If no problem occurs, replace the option.
- If the same error occurs, replace the system board.
6. Plug in and power on
• Select Continue to clear the message and continue printing.
• Install a different hard disk before performing any operations that require a hard disk.
• If this does not fix the problem, replace the system board. See
on page
4-163.
• Select Continue to clear the message and continue processing.
• Any information not previously stored on the hard disk is deleted.
• Delete fonts, macros, and other data stored on the hard disk.
• Install a larger hard disk.
• If this does not fix the problem, replace the system board. See
on page
4-163.
• Select Continue to clear the message and continue printing.
• Format the disk.
• If the error message remains, replace the hard disk.
• If this does not fix the problem, replace the system board. See
on page
4-163.
• Select Continue to clear the message and continue printing.
• Format the disk.
• If the error message remains, replace the hard disk.
• If this does not fix the problem, replace the system board. See
on page
4-163.
• Select Continue to clear the message and continue printing.
• Show Me, View Supplies, and Tell Me More displays additional information.
• Order a replacement fuser. When print quality is reduced, install the new fuser using the
instruction sheet that comes with the replacement fuser.
Note: Be sure to reset the fuser count. See
• If this does not fix the problem, replace the system board.See
on page
4-163.
"System board removal" on
"System board removal" on
"System board removal"
"System board removal"
"System board removal"
"System board removal"
"Reset Fuser Cnt" on page
"System board removal"
Previous
Next
Go Back
3-28.
Advertisement
Table of Contents
