Table of Contents
Advertisement
5026
Note: When replacing either the front or rear cartridge guide wheel, be careful to not let the non-
defective cartridge guide wheel fall off.
Installation note: Inspect carefully if the cartridge guide wheel is seated properly on the cartridge
guide before reinstalling the screw on the cartridge guide.
Cartridge motor 1/fuser cable removal
Remove the LVPS. See
1.
Disconnect the connectors in JCARTP1 (A) and JCARTS1 (B) on the system board.
2.
Service Manual
4-74
"Low-voltage power supply (LVPS) removal" on page
4-127.
Previous
Next
Go Back
Advertisement
Table of Contents
