Table of Contents
Advertisement
Multipurpose feeder (MPF) paper present sensor
Remove the right cover. See
1.
2.
Remove the standard 550-sheet input tray.
Remove the rear frame cover. See
3.
Remove the Low-voltage power supply (LVPS). See
4.
page
4-127.
5.
Remove the three screws (A) securing the tray rail that contains the paper present sensor.
Remove the JMPFPP1 connector (B) from the system board, then remove the cable.
6.
Installation note: Pay attention to the routing of the cable.
"Right cover removal" on page
"Rear frame cover removal" on page
"Low-voltage power supply (LVPS) removal" on
A
B
4-51.
4-47.
Repair information
5026
Previous
Next
Go Back
4-137
Advertisement
Table of Contents
