Selecting An Input Image; Selecting Outputs And Target Frame Memory - Sony MVS-8000X System User Manual

Selecting an Input Image

For the input image to frame memory, you can use either the signal selected on
one of the two frame memory source buses or a dedicated color matte signal.
When using the signal on frame memory source bus 1 or 2 for the input image,
select the signal as described below.
Selecting the signal on a frame memory source bus
As an example, to select a signal on frame memory source bus 1, use the
following procedure.
1
2
3
To select a signal with a key or DME effect applied on the frame
memory source bus
In the key control block or in the M/E-1 >Key1 >Processed Key menu, press
the [FM FEED] button.
This automatically assigns the key fill and key source signals being keyed by
the currently selected keyer to frame memory source buses 1 and 2.
When DME is selected on the keyer, the key fill and key source signals to
which a DME effect is applied are assigned.

Selecting Outputs and Target Frame Memory

Selecting outputs (FM) and target frame memory
The following description applies to the case of settings for FM1&2, but the
procedures are similar for the other cases.
1
306
Still Image Operations
Using the bank selection buttons in the auxiliary bus control block, select
the desired bank.
In the auxiliary bus control block, press the AUX delegation button to
which frame memory source bus 1 is allocated, turning it on.
For allocation of buses to the AUX delegation buttons, see "Assigning a
Bus to an AUX Delegation Button" in Chapter 19 (Volume 3).
In the key row of the bank selected in step 1, select the signal to be used
for the input image.
In the Frame Memory menu, press one of VF1 to VF4, and select the
required HF menu.