Master Timelines; Sequence Of Keyframe Operations - Sony MVS-8000X System User Manual

pause set on a keyframe, the execution range is up to that point. Pressing the
[RUN] button again resumes the effect, which then runs to the next pause point
or the end of the effect.
Run mode setting
You can select from the following run modes for when the effect is executed.
DIRECTION: Specify the effect execution direction.
STOP NEXT KF: Run the effect, and stop at the next keyframe.
EFFECT LOOP: Repeat the effect in an endless loop.
Make these settings in the keyframe control block. (See "Run mode setting"
(page 696).)

Master Timelines

You can save the regions selected for a keyframe effect and the register
numbers saved in the regions in a master timeline register so that operation can
be applied to two or more regions at a time.
Master timeline registers can be saved or recalled from the numeric keypad
control block or using a menu operation.
For more details, see "Creating and Saving a Master Timeline" (page 733).

Sequence of Keyframe Operations

The following table shows the principal operations involved in the sequence
from creating keyframes to executing an effect. For details of each operation,
see the page number in parenthesis.
For the overview of keyframes, see "Keyframes" in Chapter 1 (Volume 1).
696
Keyframes
Recalling a register (see page 702)
To create a new effect, recall an empty register; to edit an effect, open the
register containing it.
Specifying the region and edit points (see page 705)
Select the region in which editing applies, and set the edit points.
v
v