Extracting Images From Video Tape - Sony MVS-8000X System User Manual

Multi format switcher system

Hide thumbs Also See for MVS-8000X System:

Table of Contents

Extracting Images from Video Tape

By recording a clip or still image stored on a video tape as a single clip (single

file) under certain rules, you can automatically extract an image from the clip,

and save as a separate frame memory file.

When the signal format is 1080P, this function cannot be used.

Relation between recorded state of video tape and files after

The extraction is carried out according to the following rules.

Example 1: When only video signal clips and a still image are

recorded (single files)

Result of extraction:

Each section surrounded by red marker frames is extracted as a clip (main file).

If the red markers surround a single frame, then it is extracted as a still image.

In the case above two clip files (main files) are extracted, and one still image

Managing Images Using a DDR/VTR

Make sure to include that the red or blue image inserted at the beginning

when the backup was made. If this image is not found, the clip or still

image will not be played back correctly.

This starts the restore operation, and when completed a message appears.

Stop the playback at the external device, and press the [OK] button.

Red: red marker frame