Sony MVS-8000X System User Manual page 278

Setting the DME wipe position (Positioner)
1
2
3
4
To return the DME wipe pattern position to the center of the screen
In the <Position> group, press [Center].
Displaying and moving the position of the DME wipe pattern
(position select)
1
278
Basic Procedure for DME Wipe Settings
Display indications when multiple channels are selected at the same
time
The indications on the knobs show the settings of the lowest-numbered
channel. When you turn the knobs to adjust the settings, this changes the
settings on the other channels by the same amount.
In the M/E-1 >DME Wipe menu, select HF5 'Modify.'
The Modify menu appears.
Depending on whether the DME wipe pattern is in one-channel mode or
two-channel mode, proceed as follows.
For a pattern in one-channel mode: press [1st Ch], turning it on.
For a pattern in two-channel mode: from the <Ch Select> group, select
the corresponding channel. You can select more than one channel at
the same time.
In the <Position> group, press [Position], turning it on.
Set the following parameters.
Knob Parameter Adjustment
1 H Horizontal position
2 V Vertical position
Display indications when multiple channels are selected at the same
time
The indications on the knobs show the settings of the lowest-numbered
channel. When you turn the knobs to adjust the settings, this changes the
settings on the other channels by the same amount.
In the M/E-1 >DME Wipe menu, select HF5 'Modify.'
The Modify menu appears.
Setting values
–200.00 to +200.00
–200.00 to +200.00