Sony MVS-8000X System User Manual page 279

In the <Position Select> group, the one of the [Top Left], [Top Right],
[Bottom Left], and [Bottom Right] buttons that is on indicates the current
display position of the DME wipe pattern.
2
In the <Position> group, press [Position], turning it on.
3
Depending on whether the DME wipe pattern is in one-channel mode or
two-channel mode, proceed as follows.
In one-channel mode: press [1st Ch], turning it on.
In two-channel mode: from the <Ch Select> group, select the
corresponding channel. You can select more than one channel at the
same time.
4
To move the position of the DME wipe pattern, press the button where you
want to move to, turning it on.
The DME wipe pattern displayed on the screen moves to the position of
the specified button.
Setting relative positions to move the DME wipe pattern
In two-channel mode, use the following procedure.
1
In the M/E-1 >DME Wipe menu, select HF5 'Modify.'
The Modify menu appears.
2
In the <Ch Select> group, select the target channels.
3
Press [Position] in the <Position> group, turning it on.
4
Set the following parameters.
Knob
4
5
For details of the method of DME wipe pattern selection, see "DME Wipe
Pattern Selection" (page 273).
Setting the DME wipe pattern size (Size)
1
In the M/E-1 >DME Wipe menu, select HF5 'Modify.'
Parameter Adjustment
Relative H Relative movement in the
horizontal direction
Relative V Relative movement in the vertical
direction
Setting values
–400.00 to +400.00
–400.00 to +400.00
Basic Procedure for DME Wipe Settings
279