Table of Contents
Advertisement
42
Selenio X100
Installation and Operation Manual
AFD-VI-WSS Insertion
14:9 Pillar Box
16:9 Cut
4:3->21:9 Ltr
16:9 Letter Box
14:9 Letter Box
4:3 Cut
16:9->21:9 Ltr
Custom Up/Down/Cross ARC 1-5
AFD
AFD-ALTR
AFD-Custom Map
SD Width
In some regions, SD-SDI normal analog blanking is not part of the 4:3 active video area,
causing the 4:3 image to have an active video length of 702 (PAL/625) or 704 (NTSC/525)
instead of 720. In these situations, the ARC will need adjustments. Use the SDF Width
parameter to select whether to ignore SD nominal analog blanking. Options are 720
(default) and 702 (PAL) / 704 (NTSC).
AFD Crop Enable
This control enables the cropping function in the AFD control (an AFD option must first be
selected in the ARC Control field). Options are Yes and No.
SD Out Aspect Ratio
Use this parameter to set the aspect ratio of the SD-SDI output when ARC Control > Mode
is set to SD-ARC. Options are 4:3 and 16:9.
The presence of incoming embedded AFD, VI, and WSS data is shown the Status
parameters. AFD, VI and WSS data can be passed from input to output, or it can be
generated manually or automatically by the Selenio X100. This function is controlled by the
AFD-VI-WSS Insertion options.
The AFD, VI, and WSS Insert parameters also offer the ability to Remove the code.
Mode
Set the Current Mode if you want to work in the current conversion mode that you are
already using, rather than setting a specific up, down or cross mode.
Advertisement
Table of Contents
