Table of Contents
Advertisement
160
Appendix B
Servicing
4
From the inside of the X100 chassis, angle the connector end of the analog video
submodule through the rear panel cutout and then align the multipin connector with its
mate on the main board
Angle
connectors
through rear
cutout.
Figure B-20. Aligning the Submodule
5
Once alignment is visually confirmed, press down towards the main board.
If properly positioned, the four corner mounting holes will align with the standoffs on
the main board.
6
Secure the submodule using four provided screws
Figure B-21. Securing the Submodule
7
Replace the cover plate (ensuring the labeling faces the rear), and then secure it with the
two pan head screws
(Figure
B-20).
(Figure
B-22).
(Figure
B-21).
Advertisement
Table of Contents
