Table of Contents
Advertisement
Profanity delay requires the installation of one X100OPT-SK-PD software key.
Program Content
Backup, Bail-Out, Trouble Slide
Figure 3-3 Profanity (Program Delay)
Follow these steps to use the feature:
1
At Video Input Control and Status > Input Routing, feed the program content into the
primary channel (Proc Ch 1 Source).
Feed the backup or "bail-out" source to the secondary channel (Proc Ch 2 Source).
Or
Convert a trouble slide to a logo (see
details) and then upload the logo to the X100, enabling it in the second channel as an
alternate bail-out source.
2
Set the desired profanity delay value using Video Output and Routing > Program Delay
> Delay Channel 1.
3
Once you have set the profanity delay value, the following three options are available:
Note: In profanity delay mode, on-screen display is only available on the non-delayed
channel.
To switch the delayed program content over to the backup (or bail-out) source or trouble
slide, toggle Video Output and Routing > Program Delay > Profanity Bail Out to Yes.
This action switches all physical video outputs that are connected to Processing Channel 1
(the delayed program content) to Processing Channel 2 (the backup, bailout or trouble
slide).
To configure the X100 to operate in individual channel delay mode, set the Operation
Mode to Dual Channel. Depending on whether you have one or two X100OPT-SK-PD
software keys, the Delay Channel control slide bar is then enabled for each channel. The
resolution for the channel delay is displayed in frames; the maximum duration is dependent
on the configuration shown in the Selenio X100 Delays Table.
Profanity (Program) Delay
OPTIONAL MEMORY
(20s)
SDI
Clean
AES
2 x1
Switcher
DATA
Processing Channel 1 (delayed program content is routed to the master control
switcher, for example)
Processing Channel 2 (backup, bailout or trouble slide)
Processing Channel 1 Undelayed + On-Screen Display (to the master control operator's
picture monitor, for example)
Individual Channel Delay Mode (Dual Channel Mode)
Master Control
Delayed Program Content
Master Control
Undelayed Program Content
Operator's
Picture Monitor
Logo Generation and Insertion
Selenio X100
Installation and Operation Manual
Delayed Program Content
Switcher
on page 56 for
33
Advertisement
Table of Contents
