Imagine Selenio X100 Installation And Operation Manual page 126

114
Selenio X100
Installation and Operation Manual
Table 4-6. DTS Neural Surround Audio MultiMerge Parameters (Continued)
Downmix L/R Encoding
Mode
Downmix LFE Cutoff
Multi Final Limiter
Ceiling
Stereo Final Limiter
Ceiling
Table 4-7. Input Selection Mode Option Descriptions
Option Notes

Mix






Multi




Stereo




Aux




Multi Detect


Specifies the encoding mode for the left and right
channels
Specifies the cutoff frequency of the input LFE
channel
Specifies the threshold where final limiting on the
surround output occurs
Specifies the threshold where final limiting on the
auxiliary stereo output occurs
This option sums the Aux input to the L/R of the 5.1 input.
The AES1, AES2, AES3 inputs are 5.1 (L/R, C/LFE, Ls/Rs) in.
The AES4 input is 2.0 in (L/R) in.
The AES1 output is a sum of AES 1 and AES 4 (AES1L + AES4L, AES1R + AES4R).
The AES2 output is C/LFE.
The AES3 output is LsRs.
This option only sources audio from the 5.1 input.
Inputs are AES1 (L/R), AES2 (C/LFE), AES3 (Ls/Rs).
Outputs are AES1 (L/R), AES2 (C/LFE), AES3 (Ls/Rs).
AES4 is not used
Audio is sourced from only the L/R pair, while simultaneously muting the C/LFE and Ls/Rs pairs
of the 5.1 input (used in situations where there is information on the other inputs that you
would want to ignore).
Input is AES1 (L/R)
Output is AES1 (L/R)
AES2, AES3, AES4 are not used
This option only sources audio from the Aux input.
Input is AES4 (L/R).
Output is AES4 (L/R).
AES1, AES2, AES3 is not used
If audio is present on the 5.1 input, the Aux input is overridden.
Inputs are 2.0 on AES1 (L/R) or 5.1 on AES1 (L/R), AES2 (C/LFE), AES3 (Ls/Rs) or 2.0 on AES4 (L/
R).
Outputs are 5.1 on AES1 (L/R), AES2 (C/LFE), AES3 (Ls/Rs) and 2.0 on AES4 (L/R)
Phantom Center

Hard Center

0 Hz

60 Hz

80 Hz

100 Hz

120 Hz

140 Hz

-20 dBFS to 0 dBFS
-20 dBFS to 0 dBFS