Table of Contents
Advertisement
Fan Module Replacement (131-100021000)
Each front fan module (part number 131-100021000) is individually mounted and
connected. The wiring connector to each fan enters from its top right corner (when viewing
the fans from inside the frame). The number 2 fan is aligned differently: the wires enter at
the bottom left corner. Follow these steps to remove and replace a fan:
1
Disconnect both AC power cords to the unit.
2
Remove the front panel control assembly, as described on page 149.
3
Remove the two mounting screws for the failed fan.
4
Use a small screwdriver to carefully twist and release the locking tab, and then unplug the
fan's power connector
Figure B-6. Fan Wires
5
Remove the failed fan, and then attach the new fan using the screws provided.
Figure B-7. Fan Direction
6
Attach the connector to the fan, and then reverse the steps found in
Replacement
(Figure
Carefully twist and
open connector with
screwdriver
Ensure the new fan is forcing air into the frame
on page 148.
B-6).
(Figure
Airflow
direction
Selenio X100
Installation and Operation Manual
B-7).
Cover Removal and
151
Advertisement
Table of Contents
