Table of Contents
Advertisement
162
Appendix B
Servicing
Animated Logo Generator/Inserter and Program Delay Submodule
Follow these steps to install the X100OPT-MEMMOD8GB or X100OPT-MEMMOD16GB
memory submodule, required for the animated logo and program delay options:
1
Remove the top cover, as described on page 148, ensuring both AC power cords are
unplugged.
2
Orient the memory sub board as shown, so that its four mounting holes and the stacking
connector align with the four standoffs and connector on the main board.
Figure B-24. Installing Memory Submodule
3
Once aligned visually, press the memory sub board down onto the main board.
4
Secure the memory sub board with four M3 pan head screws provided.
5
Replace the X100 cover, by reversing the steps described in
Replacement
on page 148.
Cover Removal and
Advertisement
Table of Contents
