Selenio X100; System Presets; Sfp+Hdmi+Out Operation - Imagine Selenio X100 Installation And Operation Manual

Intelligent dual?channel frame synchronizer and converter

Table of Contents

A system preset is a snapshot of all the parameter values on the system. X100 system

presets can be created or imported from its Silverlight interface. System preset files can also

be renamed, removed or exported from the same interface. A total of 20 system presets are

supported.

To work with some older control panels, the Load Preset and Save Preset parameters are

available in the Misc > Other.

Note:

index-based, rather than name-based, and are saved as SavedPreset0xx.

In addition to the built-in HDMI output at the back of the frame, the Selenio X100 also

supports HDMI output using the optional SFP+HDMI+OUT SFP module. Proper setup is

required to make this SFP function correctly. Ensure that you correctly set these controls:



The Output Speaker Mapping parameter sets the Channel Allocation (CA) information,

which can be found in the Audio Infoframe data byte 4 of the HDMI output. The channel

allocation uses the mapping shown in this table:

Ensure that you select a valid speaker mapping for the specified number of output

channels; otherwise the HDMI audio channels output may be undetermined.

Table 3-14 Output Speaker Mapping

Speaker

Mapping

Audio Channel Number*

Number

Presets that are accessed through the Load Preset and Save Preset parameters are

Misc > SFP > Output Channels Number (sets the number of HDMI output audio

channels)

Misc > SFP > Output Speaker Mapping (sets the mapping between HDMI audio

channels and speakers)

LFE

Selenio X100

Installation and Operation Manual

Table of Contents