Changing The Pc Network Settings - Imagine Selenio X100 Installation And Operation Manual

Changing the PC Network Settings

In unusual situations, such as correcting a failed software upgrade, you may need to change
your PC network settings. Follow these steps to change the settings:
1 Change the IP Address of the PC to match that of the Selenio X100, by following theses
steps:
a
This opens the Control Panel window.
b
c
This opens a new Local Area Connection Properties window.
d
The IP Address of the Internet Protocol TCP/IP Properties box appears.
Figure 2-9 shows the portion of the Internet Protocol TCP/IP Properties box where you
enter the IP Address, Subnet Mask, and Default Gateway of your PC.
e
You may need to re-select this option later when you revert back to the original PC IP
Address.
f
g
This value applies to Class C IP addresses; confirm the number with your network
administrator.
h
Click Start > Settings and then click Control Panel.
Double-click Network and Dial-up Connections, and then double-click Local Area
Connection.
Click the General tab, and then click Properties.
On the General tab, select Internet Protocol (TCP/IP), and then click Properties...,
ensuring you are working on the correct Ethernet adapter for the CCS network.
Note whether Obtain an IP address automatically is selected.
Select Use the following IP address, and in the IP address box, type a new
computer IP Address to match the first three octets of the IP Address of the Selenio
X100, and then add a different fourth octet.
(For example, if the Selenio X100 IP Address is 192.168.100.50, you could type
192.168.100.181).
In the Subnet Mask field, type:
Enter the same Default Gateway number as the one on the Selenio X100, or leave
blank.
Installation and Operation Manual
255.255.255.0
Selenio X100 19