Table of Contents
Advertisement
20
Selenio X100
Installation
i
Click OK to close the TCP/IP Properties box, and then close the two Local Area
Connection boxes.
2
Verify the network settings were accepted by following the ipconfig procedure, as described
below:
a
Click Start, point to Programs > Accessories and then click Command Prompt to
open the Command Prompt window on the PC.
b
Type the following at the MS-DOS command prompt, and then press ENTER:
ipconfig
The IP Address, Subnet Mask, and Default Gateway of the PC appear. (In some
situations, the Default Gateway value is not shown. See Figure 2-9).
Figure 2-10 IP Address, Subnet Mask and Default Gateway of PC.
c
Write down the IP Address, Subnet Mask, and Default Gateway numbers of your
PC.
d
Compare the network numbers of the X100 with the numbers found in step 2c.
In general, the two Subnet Mask and Default Gateway numbers should be identical. The
first three octets of the two IP Addresses also are generally identical. For example, if the
Selenio X100 has an IP Address of 192.168.248.50, the PC could have an IP Address of
192.168.248.181.
3
If the network settings match, click Close.
Note: Where more than one network is involved and the Point-to-Point option has been
selected (see CCS Navigator online help), the network address values may be entirely
different.
Advertisement
Table of Contents
