Table of Contents
Advertisement
Analog Video Input/Output Module (X100OPT-AVIO)
Follow these steps to install the optional analog video input/output module:
1
Remove the top cover, as described on page 132, ensuring both AC power cords are
disconnected.
2
Remove and set aside the two screws from the rear cover plate
Figure B-18. Removal of Rear Plate
3
Using the HD-BNC Nut Tool, prepare the analog video submodule by removing the twelve
HD-BNC nuts, and then set them aside for later
Figure B-19. Removal of HD-BNC Nuts
Installation and Operation Manual
(Figure
B-18).
Remove and retain
screws.
(Figure
B-19).
Selenio X100
159
Advertisement
Table of Contents
