Table of Contents
Advertisement
Installation of Advanced Audio Processing Submodule (X100OPT-ADVAUD)
To use advanced audio processing in the Selenio X100, you must install an
X100OPT-ADVAUD audio submodule and purchase the appropriate software license keys.
Follow these steps to install the audio submodule:
1
Remove the top cover, as described on page 148, ensuring both AC power cords are
unplugged.
Figure B-9. Location of Advanced Audio Processing Submodule
2
Position and align the audio submodule over the standoffs on the X100 motherboard, and
then gently press it into place
3
Secure the audio processing module to the motherboard with four M3X5 mm screws
(supplied) at the locations indicated by the arrows.
Figure B-10. Aligning with Standoffs
4
Replace the X100 cover, by reversing the steps described in
Replacement
Submodule
Front Panel
(Figure
B-10).
Screws
on page 148.
Selenio X100
Installation and Operation Manual
Cover Removal and
153
Advertisement
Table of Contents
