Chapter Two: System Setup; System Bios Setup - Inspur TS860 User Manual

1. First correctly connect the monitor, keyboard and mouse. Then connect all power modules
with the effective power strip or outlet by using the attached power cable.
2. Press the switch button on the front panel of the server, the fan will run and system start to
power up and self-test.
3. The server will boot from the first device set in BIOS starting-up management.
If the device is unavailable, it will continue to boot the rest corresponding device.。
Notes：

according to the configured memory capacity, it will take 4 minutes or longer to connect
to the server's monitor.。
Close the server
1. Closing down the server can be achieved through the operation under the operating
system。
2. Closing down the server can be achieved through manually pressing the switch button on
the front panel.。
Note: after the above two ways, although the server stops running, some voltage
is still in a usable state, when the system can start up through remote management; to achieve
complete shut down, you need to disconnect the system's AC power (unplugging the power line or
turning off power strip)

Chapter two: System Setup

In this chapter, the BIOS function setup of this server is introduced. Only the operator or the
administrator with qualification of system maintenance can implement these operations described
in this part.
2.1

system BIOS setup

BIOS is a basic input and output system. The system parameter and the hard disk parameter
can be adjusted through special set program. BIOS has great influence on the system start and
running, so setting parameters improperly may arose the conflict among the hardware resource, or
reduce the system run performance. Hence understanding the BIOS setup is significant to the
configuration of your server. If no especial requirement, you are suggested to use the default value
and not alter the parameters optionally.
Notes:
1. Before the server BIOS setup is altered, please record the corresponding original setup.