Mainboard Bios Setup; Notes; Chapter Three System Setup - Inspur NF5270M3 User Manual

Chapter Three System Setup

This chapter introduces BIOS function setup and mainboard jumper of the server.
All operations described in this section are only limited to operators or administrators
with system maintenance qualifi cation.

3.1 Mainboard BIOS Setup

BIOS is a basic input and output system. The system parameter and the hard
drive parameter can be adjusted through special set program. BIOS has great infl uence
on the system start and running so that setting parameters improperly may arose the
confl ict among the hardware resource, or fall down the system run performance. Hence
understanding the BIOS setup is significant to the configuration of your server. If
no especial requirement, you are suggested to use the default value and not alter the
parameters optionally.

Notes

1. Before the server BIOS setup is altered, please record the corresponding
original setup. Hence when there are operating problems in the system due to the
option altered, the setup can revert.
2. Ordinarily the factory default system value is the optimized setup. Don't
try to alter the parameters before you understand their denotations.
3. The common setup is introduced in detail in this paper. The less referred
options in the application procedure are simply explained or not.
4. The content of the BIOS is diverse based on the different confi gurations of
the products; hence the detailed introduction is elided.
3.1.1 How to Enter the BIOS Setup
Power on the server, system starts to guide, when the following prompts on the
screen:
"Press <DEL> to SETUP or <TAB> to POST", press 【 DEL 】 , wait a few
seconds, to enter system BIOS setup.
If user could not enter setup procedure via the above operation, please press 【 Ctrl 】
- 【 Alt 】 - 【 Del 】 to restart system, repeat the above operation (if system prompts to
13