Inspur TS860 User Manual page 42

Recording, Maintenance and Firmware Update.
On the right top of the interface, there are user name and login user's user groups, you can
also use Refresh (refresh the page), Print (print pages), Logout (cancellation) and other shortcut
menu.
1. Dashboard menu
In this interface, you can see the Firmware version of management chip, modification time,
MAC address and other information.
Click [Edit] after Network Information, enters network setup interface, you can set the IP
address and gateway here.
The windows under Remote Control display remote control panel information. Click [Launch]
after Remote Control, logging in control panel. If prompted to install Jviewer browser when using,
please install according to the prompt.
In this interface, you can also check the relevant sensor information, such as power supply
module, CPU voltage and temperature, system fan speed, control module fan speed, hard disk and
power module status.
2. FRU Information menu
This menu displays FRU information, including Basic Information、Chassis Information、
Board Information, Product Information and other information. Basic Information displays FRU
device ID and name. the other three options correspond the information of chassis, motherboard
and whole machine type respectively. Detailed information is as follows:
3. Server Health menu
From this menu, you can check server health-related data, including Sensor Readings (sensor
readings), Event Log (Event Log), System and Audit Log, BSOD Screen, as shown below: