Chapter Three: Operating System Installation - Inspur TS860 User Manual

Jumper
Function description
name
J6 CMOS jumper
Notes:
1. You must shut down the system and cut off power supply when clearing the CMOS and
need to keep for 5 seconds after short connecting pin 2-3; then re-short connecting pin1 with pin 2
of J17 jumper to restore the original state,
2. After completing this operation, please install the upper panel.

Chapter Three: Operating System Installation

Manual setup of the operating system is introduced with emphasis in this chapter, including
Windows Server 2012 and Red Hat Enterprise Linux 6.4[x64system].
During manual setup of the operating system, some operating system may need the floppy
drive or Inspur driver U disk to load the driving program of hard disc controller. Refer to the
readme.pdf file under the root directory in Inspur system driving program CD for the making
method of the driving program floppy disk. And the making method and considerations of using
Inspur driver U disk can refer to the attached Instructions of Inspur Driver U Disk.
In the driver making interface of the driving program CD, the controller driving program to
be loaded during the setup of the operating system under the relevant configuration can be seen
and made.
This installation instruction takes external LSI 9271-8i SAS RAID card as instance. If your
server is configured with other external RAID card, please refer to the user's manual in the CD to
add the driving program for the hard disk controller. For network card driver, video card driver
and system patch program, the guidance in the chapter can also be referred for setup.
It is suggested that you confirm in advance that whether the purchased machine
Jumper's function
Pin 1-2 short circuit is in normal state (default)
Pin 2-3 short circuit is in cleared state