Inspur TS860 User Manual page 20

Policy Performance/Balanced
Energy/Energy Efficient
Dynamic
Enabled/Disabled
Switching
Turbo Mode Enabled/Disabled
T-States Enabled/Disabled
C-States Enabled/Disabled
* Active Processor Cores
Set the number of cores in use of each CPU. Default is [All]. This option works for all CPUs in
the system (number of CPU cores are associated with specific models)
* Intel HT Technology
Enable or disable Intel hyper-threading technology (only works for CPUs with
hyper-threading function). This option works for all CPUs in the system. Default is Enabled。
● Platform Information
Display ME version, working status and other information
● SATA Configuration
To check SATA status on each SATA ports and set SATA controller mode.
* SATA Controller
To enable or disable integrated SATA controller. Default is [Enabled]
* HDC Configure As
To set integrated SATA controller mode, including [IDE], [AHCI](default)and[RAID]
Use integrated SATA controller. If you would have a serial device used as parallel IDE a
pops up selection window by pressing the [enter] key.
When disabling EIST Support, this option is not
visible. Default is Balanced Performance.
Whether to enable
characteristics of power consumption performance
adjustment, Default is Enabled.
Enable or disable processor turbo mode. When
enabling, it intelligently closes some cores of no use
through the analysis of the current CPU load, leaving
the energy to the core in use, and make them run at a
higher frequency, to further improve performance. In
contrary, when multiple cores are needed, relevant
cores are opened dynamically, and frequency is
adjusted dynamically. Default is Enabled.
Enable or disable Processor Throttling State. When
enabling, system power dissipation and temperature
are adjusted through the adjustment of per unit time
CPU Clock On/（Clock On + Clock Off）ratio.
Default is Disabled
Enable or disable C-State energy conservation state.
When enabling, processor enters C-State energy
saving mode; when disabling, processor works at
C0 mode, that is normal operation at full speed.
Default is Enabled.
dynamic transformation