Restarting The Server - Inspur TS860 User Manual

to earth-connect the other end to provide electrostatic protection when dismounting the server.

4.1 Restarting the Server

When a failure occurs, try to restart the machine according to the following methods first.
Purpose
Restart the software, clear up system RAM and restart the operating
system.
Clear up system RAM, self-check the POST again and restart the
operating system.
Cold boot again, switch off and restart the system power in order to clear
up the system RAM, to self-check the POST again, to restart the
operating system and to power up all the peripherals again.
4.2 Problems When Starting the Machine
Some problems often occur when the machine is started, generally due to incorrect hardware
installation and configuration. You may find and solve the problems referring to the following
methods.
4.2.1 System cannot be powered up
After pressing the power button, the power light is not on and the system maintains non-electric
state. Please try the following steps:
1. Check whether your power socket can supply power normally and the power cable is correctly
connected.
2. Repeatedly press the power button to start the machine (pay attention not to exerting too much
force).
3. Disconnect the power cable from the system and open the chassis to check.
4. Check the fastness of the cable connection and accessory plugging in the chassis.
5. Remove other external components other than Inspur's.
6. Pack the chassis, connect the power cable correctly and start the machine.
4.2.2 Monitor doesn't display
It can be powered on (the host can start and run normally), but the monitor doesn't work:
1. Check the correctness and fastness of the signal cable and power cable connected to the
monitor.
How to operate
<Ctrl+Alt+Del>
Reset button
Power button