Inspur TS860 User Manual page 32

Take out Inspur driver CD, and reboot system. Complete the installation of Windows
Server 2012.
3.2 Manually Installation of Red Hat Enterprise Linux 6.4
3.2.1 Preparation before installation
● Red Hat Enterprise Linux 6.4 installation CD (DVD)（X86_64bit version）
●Inspur driver CD
●
No need of adding controller driver for external LSI 9271-8i SAS RAID
3.2.2 Installation steps
1. Connect USB driver to the server. Power up and start the system, put the installation disk
into the driver (here taking using DVD installation disk as example), entering BIOS setup and
select to boot from the CD.
2. system enters Welcome to Red Hat Enterprise Linux 6.4！interface with following options:
Install or upgrade an existing system
Install system with basic video driver
Rescue installed system
Boot from local driver
You can use the up and down arrow keys to select an option, this is the first time we install by
default. Select "Install or upgrade an existing system".
Note: If you do not need to add a hard disk controller drivers, press [Enter] key to continue
the installation.
3. System configured RAID card need a hard disk controller driver, after selecting "Install or
upgrade an existing system", press [Tab] and switch to the edit state. Enter linux dd after vmlinuz
initrd=initrd.img, press [enter] to continue the installation.
① The screen prompts: "Do you have a driver disk?", select [Yes], press [enter] to continue.
②The screen prompts: "Driver Disk Source", we use USB flash disk here, please select
[sda],and then select [OK] to continue.
③The screen prompts: "Driver Disk Source", because USB flash disk has many partition,
please select the partition where driver is and then select [OK] to continue.
④The screen prompts: "Select driver disk image", select the drive mirroring needed loading,
and then select [OK] to begin loading driver.
⑤finishing loading, system prompts :"More Drivers Disk?" asking whether it is needed to
load other driver. Here we select [No] to complete the driver loading.
4. The screen prompts: Disc Found。
Here select [Skip] to skip medium test, press [enter] to continue.