Inspur TS860 User Manual page 21

storage device, please set this option to [IDE]
Use integrated SATA controller, if no RAID, and connect to 1-2 SATA, please set this option
to[AHCI]
Use integrated SATA controller, if to make SATA Host RAID， please set this option to[RAID]
* Serial ATA Port 0/1
Display SATA status connected to SATA ports
● QPI Configuration
* QPI General Configuration
To check QPI status and configure the general options
BIOS Setting
Link Speed Mode
Link Frequency Select
Legacy VGA Socket
* QPI Per Socket Configuration
To set QPI of each processor, including assign proportion of CPU bus resources, IO resources
and MMIO resources.
● Memory Configuration
To set the related parameters of memory
BIOS Setting
DDR Speed
Rank Margin Tool
RMT Loop count
Data Scrambling
VMSE RMT
VMSE RMT CPGC
Pattern Length
Memory Topology
Options
Fast/Slow
6.4GB/s、7.2GB/s、
8.0GB/s、Auto、
Use Per Link Setting
0/1/2/3/4/5/6/7
Options
Auto/1067/1333/
1600
Enable/Disable
1~31
Enable/Disable
Enable/Disable
0~30
No Options
Description
Select QPI link speed, default is Fast。
Select link frequency, default is Auto。
The value determines to
card on PCIe slots drawn from Socket.
Description
Set memory working frequency (MHz).
when it is "Auto", the memory will work at
the highest frequency supported by CPU and
installed memory. Default is Auto
Whether to enable Rank Margin Tool,
enabling Rank Margin Toolcan test the
memory Margin; default is Disable.
Set RMT cycles
Whether to enable memory data scrambling,
default is Enable。
Whether to enable VMSE RMT default is
Disable
Set VMSE RMT cycles
Display topology of installed memory,
including memory installation location,
frequency, manufacturers, capacity and other
information. If it cannot show on a screen
enable which display