Advanced Settings; Custom Services Setup - Xerox WorkCentre 5755 System Administrator Manual

Advanced Settings

The Advanced setting page allows you to designate up to four types of broadcast packets that allows
the network controller to briefly resume activity and respond when the machine is in sleep mode.
1. From the Sleep Mode Settings page, click on the [Advanced Settings] button.
2. In the Packet Priority area, select a broadcast packet from the Packet Priority list. Use the
[Increase Priority] and [Decrease Priority] buttons to increase or decrease the selected
broadcast packet's priority.
The Packets that Briefly Resume Network Controller area displays packet priorities for up to four
packet types.
3. Click on the [Apply] button.
4. Click on the [OK] button when you see the message "Properties have been successfully
modified".
Note: When you click on the [Apply] button the system processes the Packet Priority list, and
applies the four packet types with the highest priorities for which the corresponding protocols are
enabled. Packet types associated with disabled protocols are skipped. The lower list then displays
the packet types that, when received by the machine in Sleep Mode, will cause the Network
Controller to briefly resume activity.
Enabling the IPv6 ND broadcast filter will only wake the machine from Sleep Mode when the
machines IPv6 Link Local address is used.

Custom Services Setup

This feature allows the System Administrator to set up Custom Services on the device. Custom Services
allows independent software vendors and partners to develop customized programs accessible directly
from the device control panel. Users can enter their authentication login at the device, and access a set
of features and options designed specifically for their business need.
Information Checklist
Before starting the procedure, ensure the following items are available or tasks have been performed:
• Ensure the device is fully functioning on the network.
• TCP/IP and HTTP protocols must be enabled on the device so that the device's web browser can be
accessed.
• Custom Service Registration (HTTP: Web Services) must be configured.
To Enable Custom Services
Note: To configure this feature or these settings access the Properties tab as a System
Administrator. For details, refer to
1. From the Properties tab, click on the [General Setup] link.
2. Select [Custom Service Setup] in the directory tree.
3. In the Setup (Required) area, ensure HTTP (SSL) and Custom Service Registration have been
configured to enable Custom Services. If they have not been enabled, click on the [Settings]
button and configure the settings and click on the [Apply] button.
4. In the Enable Custom Services area check the following checkboxes:
Access Internet Services as System Administrator
Xerox WorkCentre 5735/5740/5745/5755/5765/5775/5790
General Setup
on page 16.
System Administrator Guide
31