Configure Ip Settings Using Internet Services; Ipv4 - Xerox WorkCentre 5755 System Administrator Manual

Network Installation

Configure IP Settings using Internet Services

Note: TCP/IP and HTTP should have been initially configured, refer to
the Device on page 11 of this guide.

IPv4

Note: To configure TCP/IP Settings access the Properties tab as a System Administrator. For
details, refer to Access Internet Services as System Administrator
1. From the Properties tab, click on the [Connectivity] link.
2. Click on the [Protocols] link.
3. Select [IP (Internet Protocol)] in the directory tree, the IP (Internet Protocol) page displays.
4. Ensure that [IPv4] is selected.
5. In the General area:
a. For Protocol, the [Enabled] checkbox be enabled.
Note: If the [Enabled] checkbox for Protocol is not checked, you will not be able to access Internet
Services. TCP/IP must then be enabled from the device's user interface.
CAUTION: Disabling TCP/IP or changing the IP address will affect SLP, SNMP, NetBIOS/IP, Raw
TCP/IP Printing, SMTP, LDAP, POP3, HTTP and NTP. If TCP/IP is disabled, Internet Services will not
be available until TCP/IP is enabled from the device control panel. If you change the IP Address,
you must reference the new address within your web browser to locate the device.
b. Physical Connection will display the physical network connection. This will display
"Ethernet".
c. Select one of the following methods for obtaining a Dynamic IP address from the [IP
Address Resolution] drop-down menu:
• DHCP (Dynamic Host Configuration Protocol).
• RARP (Reverse Address Resolution Protocol).
• BOOTP (Bootstrap Protocol).
• STATIC (fixed, User-defined), this is the default selection.
d. Enter a name which corresponds to the IP Address of the device in the [Host Name] field.
If you select [Static], type the IP Addresses that applies in [Machine IP Address], [Subnet
e.
Mask], and [Gateway Address] fields.
Note: If BOOTP or DHCP address resolution mode is selected, you cannot change the IP Address,
Subnet Mask, or default gateway. If RARP address resolution mode is selected, you cannot change
the IP Address. Select [Static] if you wish to disable dynamic addressing.
f. Enter details of an identifier of the IP site to which the device is connected in the [Domain
Name] field.
g. If DNS configuration is required, enter IP Address for the [Preferred DNS Server]. Enter an IP
Address for [Alternate DNS Servers 1] and [Alternate DNS Servers 2].
Note: If DHCP or BOOTP is the IP Address Resolution setting, you cannot change the Domain
Name, Primary DNS Server, Alternate DNS Server 1, and Alternate DNS Server 2 settings.
84 Xerox WorkCentre 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide
Enable TCP/IP and HTTP at
on page 16.