Advanced Tab Settings; Printer Features Settings - Xerox DocuColor 2240 User Manual

Output Tray
Job Offset
Transparency Separators

Advanced Tab Settings

This section describes the settings of Printer Features in the
Advanced tab.
NOTE: The settings that can be selected vary depending on which
options have been installed.
1
Select the items in Printer Features under Document Options
located in the on the Advanced tab that you want to set.
2
Change the settings in the Change Setting box located at the
bottom of the tab.
3
When all setting changes are completed, select OK.

Printer Features Settings

Set the destination for the output.
• The items that can be selected vary according to whether
the Center Tray or Finisher has been installed.
Shifting the output positions of adjacent jobs (print command) or
copies (sets) is called Job Offset. The positions of adjacent jobs or
sets of copies are shifted to either sides of the output tray.
Specify whether to use transparency separators and the source of
the separators, if selected.
Select Auto for three paper source to automatically feed from the
paper tray with paper of the same size and in the same orientation
as the transparencies.
NOTE: When using Transparency Separators, be sure to load
paper of the same size and in the same orientation as
transparencies into the paper tray.
NOTE: The Transparency Separators function cannot be used in
the following situations:
• When anything other than Manual feed is selected for
Paper source in the Paper tab.
• When anything other than Transparency is selected for
Media type in the Advanced tab.
• When anything other than Center Output Tray is selected
for Output Destination of Printers Features in the
Advanced tab.
U G ( P )
S E R U I D E R I N T
2–29